Machines Function:

This machine is suitable for milling the man-made rubber, special for the used rubber.

Machines Characteristic

1.Low speed running, ensure the rubber intrinsic characteristic, and reduce the producing noise and pollutant.

2.This machine adopts two kinds of cooling way, wind and water, this will control the grinder chamber temperature up to much.

3.Use the whirlwind collection equipment, no material waste and no dust.

4.Low consume, the products granular is thin and symmetrical.

5.Can adjust the products size from 40~100mesh (0~0.5mm).

Main Technical parameter

1.Capacity:100~120Kg/H(single set)

2.Power:30kw(single set)

3.Knife material:cast iron enchased with tungsten steel.

4.Knife quantity: two pieces.

5. Overall Size: 1540×1300×1200mm (not including the conduit and other parts).

6. Weight:1600Kg/set (not including the conduit and other parts).

7. Price (EXW): $7,930

Machine’s installation and operation

1.Checking if the machine is broken in the transportation or not.

2.Need the level ground.

3.Connecting the machines system, whirlwind collection equipment and water cooling, every pipe should be sealed.

4.Checking the screw.

5.Checking the electrical wire and power, start the motor, checking the motor running direction is the same as the marked.

6.The order of starting:

Open water cooling, main motor, feeding

7.Open the chafer cover, if the material is in chafer, adjust the distance of the two knife disks, the less distance, thin material.

8.Should often check the disks, if find problem, should stop the machine at once.

9.Should often check the water pipe and the cooling system.

10.The order of stop

Feeding, main motor,water cooling, adjust the disks into big distance.

11.Checking the Aerometer, in normal, the ampere should not over 60.

12.Adjust the feeding speed according to the material, on the machine, have the timing motor, the motor can control the feeding speed.

Maintains and safety technology

1.Clean out the hard matter, like the metal, if the hard matter go into the grinder chamber, it would damage the knife disks.

2.Ensure the water cooling.

3.Often check the Aerometer.

4.Add the lube in time, the shaft should add the butter after working 2400 hours.

5.The timing motor should adjust in running, don’t adjust it when it stop.

6.When adjust the knife disks distance, it should have material in chamber, can’t rub the disks directly.

Normal trouble and method

Backout and installation

1.Loosen the screw which connecting the machine and pipe, remove the pipe, motor and belt.

2.Loosen the screw which connecting the feeding, remove the chain wheel cover, chain,feeding equipment and grinding chamber.

3.When remove the disks, first close the water.

4.Loosen the disks screw, remove the disks.